Recent content by Jsmashya13

Rear lift was 5100s with AALs.

TP14 spacer is in the front shock. Corrects driver side lean. I would have to check all that info. Not at my truck.

No spacers on truck

Lol yeah my bad. Honestly I expected a little difference in the ride quality but it I almost painful how much different it drives

Sorry 275/65/R18s

It's on the first clip setting,2 1/2" and then added top plate spacers to give a full 3" lift. Added driver side lean TP14 spacer. Trucks steering is way off from stock driving and rubbing hard at full turn. Removed all unnecessary plastic but noticed it is only rubbing back of wheel well

I put on toyo open country MT 265/75/R18's (32.6")on truck. Rims have a -12 offset. Was told numerous times these would fit on a 3" full lift with no trimming necessary. Tire is not rubbing on plastic but is rubbing on chassis at full turn

Well the lift has been completed! Truck looks great! Only problem is I don't think the alignment was done right. Getting a vibration at low speeds and tire is rubbing rear of tire well at full turn. I installed the SPC light racing UCAs and if I am not mistaken those will allow the wheels to be...

Guys I just recently lifted my truck with the 3" toytec ultimate lift, bilstein 5100s, rear AALs and SPC light racing UCAs with 18" Fuel Krank rims with 265/75/R18 Toyo open country MTs. I did a lot of research prior to doing install and was told that I should have no rubbing or scrubbing with...

How long was the install?

Yeah funds are a bit tight... Hate to have to pull truck apart again though. Are they difficult to install? Any recommendations which brand/type to get if I do decide to do it? Trying to do entire install in one day so I have no down time.

I will add in future but on a budget so if they get me a year and it doesn't effect the ride I will wait. Thanks

Guys I'm about to lift my truck with the bilstein 5100s, eibach coils and rear add a leafs. Do I have to replace upper control arms or am I good?