Discussion in '2005 - 2015 Toyota Tacoma' started by Bojangles, Aug 14, 2019 at 9:01 PM.
So i got these today, dirt cheap.
Any tips for installation?
Join TacomaForum.com Today!
Just gotta hunker down and git'r dun...
This is bout to get real interesting.
Well, everyone is entitled to make a mistake.
Those LT spacers are legit.
what color loctite?
I have red and I have green
Unbolt what's there, lift it up, put those in, and tighten the bolts to 500 ft. Lbs.
do I need washers?
Where does this one go?
That's the drive shaft shock...
You just cut your rear drive shaft in half, slip that in there and JB Weld it back together.
Only in the back, for extra leveling.
I cant wait for the final pics after everything's installed.
Green, def green...
You'll want to hand tighten the fasteners, wrap some tie wire around the stud a couple times, fill up an orange wire nut with Green Loctite and twist the ends together...
Locked and good to go!
More washers = more lift! I bet you can pick up a box of lock washers to stack up in there to get you another inch!
Another inch? The possibilities are endless with washers.. just keep on stackin... might as well go 2-3 inches. lmfao
Some coupling nuts and 8' sticks of all-thread and 44's here we come!!!!
Separate names with a comma.